Wireless (XBee based) RF Current Sensor Module

Wireless (XBee based) RF Current Sensor Module
Wireless (XBee based) RF Current Sensor Module
Brand: Berkshire Products, Inc.
Product Code: 2010
Availability: In Stock
Price: $89.95

3 or more $48.08
5 or more $46.42
Qty:     - OR -   Add to Wish List
Add to Compare

The Wireless Current sensor is designed to measure AD or DC currents up to 5 Amps at a maximum of 32V. It is designed to sense positive or negative AC current levels or high / low DC current levels and use the set points to trigger an XBee wireless module to send a notification. It can also use the XBee's timed reporitng mode to return remote current readings.

 

XBee Radio Information

The board can be used with the following types of XBee & XBeePro radios in Series 1 & 2 footprints:

  • DigiMesh2 2.4G
  • DigiMesh2 900MHz
  • 802.15.4
  • 900MHz
  • 868MHz
  • Zigbee
  • WiFi

For best results we recommend that you use XBee radios with the RP-SMA antenna connector or the mini whip antenna. These will experience the least interference from the copper areas on the PCB. The XBee radios with chip and PCB antennas will still work but their range may be reduced.

The following links are for the board manual, the Arduino Libraries and Sample code, and a ZIP file with the Schematic and PCB layout files:

 

Pictures Note: Some picture(s) show the IO Module with XBee radios attached for illustrative purposes only. XBee radios are not included and should be purchased from a vendor like Mouser or Digi-Key.

Note 1: XBee is a registered trademark of Digi International Inc.

Note 2: DigiMesh is a registered trademark of Digi International Inc.

                                                                         

Technical
Power • 8V @ 400mA – minimum • 32V maximum @ 100mA
Environmental • -30° to +65°C - Operating • -40° to +85°C - Storage • 5% to 95% Relative Humidity, non-Condensing

Write a review

Your Name:


Your Review: Note: HTML is not translated!

Rating: Bad           Good

Enter the code in the box below: